3 Common Garbage Disposal Problems

4.4
3 Common Garbage Disposal Problems

Garburator is a handy kitchen device both for the owner and the community. The article explains common garbage disposal problems one can come across.

Garburators or garbage disposals are incredibly handy kitchen gadgets to have. When performing properly the disposal grinds the food debris into fine pieces, making them easy to pass through your plumbing pipes. These garburators help keep the food debris from rotting in the landfills. Most newer homes come with a garbage disposal already installed. The garbage disposals are relatively cheaper and if maintained properly they can last for a good 10-15 years.

Check Out: Kitchen Faucet: Common Problems And Their Solutions

Use Garbage Disposal Wisely

Despite its name, the garbage disposal is not a trash can. Most garbage disposals are designed to handle only light food particles from a limited range of food items. In general, you should avoid putting the below-mentioned food scraps in the garbage disposal.

Starchy food including whole chunks of pasta, rice, and beans.

Any non-food liquid or solids including glass, paints, solvents, or plastics.

Fibrous foods such as banana peels, celery peels, or potato peels.

Hard materials such as bones, seafood shells, eggshells, etc.

In addition to the products you add to the garburator, the way you operate it also matters. Always run the cold water when starting the disposal and let it run during the disposal process. The use of cold water will allow the small amount of grease to coagulate and move through the pipes. On the other hand, warm water lets the grease thins and accumulates in the pipes, causing severe problems.

Attend The Disposal Problems Promptly

The most common garbage disposal problems homeowners come across at one time or another are discussed in the following article. Solving and fixing these problems as quickly as possible, can save your disposal and prevent bigger plumbing problems.

Clogs

A garbage problem usually has no problem in grinding the food waste. The disposal will also grind and deal with the prohibited food scraps quite a few times easily. However, the problem is what happens next? The garbage disposal clogs.

Clogs are usually the result of how the grinding material reacts to the water during the process. If the wrong type of food scraps or wrong amount and type of water is used during the grinding process, it can develop a clog in the drain trap also known as P-trap.

Clogs can also form over time when the waste line and trap drain develops a layer of coated food scraps.

There are two easy ways to prevent clogs. Firstly, only dispose of the allowed food scraps in the garburator. Secondly, always provide the disposal with plenty of water during and a few seconds after the grinding process.

Leaks

Leaks from garbage disposal can cause several problems including mold growth, foul odors, warped cabinetry, and water damage. Leaks should be identified and rectified quickly to minimize the potential damage.

The drainage hose, plumbing connections, and outer casing unit are the areas on the garbage disposals units that can develop leaks. A heavy or sharp object falling in the disposal can crack the casing and develop leaks.

A leak around the plumbing system can be rectified by small tightening and repairs. However, leaks in the drainage unit itself due to corrosions or leaks, only have one solution that is changing the disposal system overall.

Jams

If the garbage disposal is not grinding but the motor of the system is making loud humming and stuttering sounds, the inner flywheel is most likely jammed. Similar to clogs, jams are usually the result of too much waste or the wrong type of food waste being sent down the disposal.

If a disposal jams, it usually trips the onboard circuit breaker, preventing the motor from overworking and burning out.

You can fix a jammed flywheel yourself by using a wrench given with the garbage disposal and following the instructions in your owner’s manual.

If you don’t have an owner’s manual or can’t grip on the reset process, you can call the professional garburator repairs and get it fixed before it’s too late.